Palmers Stabilizer Regulator Zeta
says that this is the air system supply regulator that will save you a
lot of headaches and chrono panic! The Palmers Stabilizer regulator has
all of the features and performance of the legendary Palmers "ROCK" regulator,
but designed and built for the high pressure output needed to regulate
and stabilize pressure controlled paintgun velocity. Well suited for use
as the first stage of a 2- stage regulation system for the AutoMag or in
the role of the second stage of an on-gun or remote system for all paintguns;
with either CO2 or N2/HPA pressure supply systems. Two stage regulation
will provide approximately 25 times greater control and consistency of
the supply pressure that is allowed into the paintgun. Expansion chambers
can't even hope to block liquid CO2 the way the that the Stabilizer can,
thus virtually eliminating the chance of "hot-gun" penalties. The long
proven performance of Palmer's Regulators, makes the "STABILIZER" a must
for all pressure controlled firing systems for any paintgun.
This Palmer Stabilizer regulator is the male vertical version and is most commonly is in the vertical position connect to a paintgun. Overall regulator length is 4-7/8". Body length is 4-1/4". Body max. diameter is 1". There are 2 1/4-20 treaded ports located on body of regulator. The first port is "INPUT", the second port is for "OUTPUT". The input and output ports are on opposite sides from each other. The threading at the top of the regulator is standard Co2 tank threading like would be found on a Co2 tank valve. Regulator comes preset at approx. 500 PSI and can be adjusted to an output pressure of 0 to 900 PSI. Regulator adjustment is accomplished by turning setscrew located on the bottom of the regulator. The regulator safety vent port is located on side of regulator 1/2" up from the bottom. Features:
Questions about this product?
|
